| About Fan Dilution » |
| Fan dilution is based on the principal of diluting the products of combustion to reduce the CO² content of the discharge to below 1%.
Midtherm offers a design service for flue dilution for any gas-fired or other VLS fuel installation, and can offer systems tailored to site conditions and customer requirements. A packaged fan assisted/flue dilution system is also available. With over 27 years’ experience of this type of installation, the company can ensure compliance with the Clean Air Act, D1 and BS 6644/IGE/UP/10 part 1 edition 2. Advice is also offered on noise reduction methods. Our technical design team analyses each system on its merits taking serious consideration to compliance with the Clean Air Act Regulations as well as Environmental Health Noise Control requirements. Regulations dictate that only very low sulphur fuelled appliances are used within this type of system design.
|
|
|
|
|
| Home » Flues » Fan Dilution (Single) » | ||||||
|
The Midtherm Fluevent System is a packaged unit alternative to a conventional flue dilution system. The system offers several advantages including lower noise levels, a reduction in the amount and size of the duct/flue in the boiler house, easier installation, reduced energy costs, easy maintenance and inspection. The unit offers an aesthetic solution both internally, and externally. All that can be seen on the outside wall is the inlet / discharge all weather louvre which can be powder coated to any RAL colour.
|
| Midtherm News... |
| X-Stream Interest at Ecobuild 2010
We recently attended the Ecobuild event at Earl’s Court to promote our Solabreeze X-Stream airflow terminal. There was great interest in the Solabreeze X-Stream product from many industry sectors during the Ecobuild event.
The X-Stream louvre blade technology is a new innovation in louvre blade design achieved in collaboration with Sheffield Hallam University following a 3 year joint funded study into the aerodynamic efficiency of a standard louvre blade design. The Solabreeze airflow terminal is essentially a passive stack ventilation unit and is constructed to be used in conjunction with other devices such as openable windows, internal wall air transfer grilles and external actuated wall mounted ventilators such as the Midtherm ‘Crossvent’ unit. BSRIA benchmark testing confirmed that the new, precise blade pitch angle of the X-Stream achieves the highest airflow performance at the lowest resistance possible. |
